1. Product Features

1. Thermally conductive, insulating, flame retardant

2. Good weather resistance and hydrophobic properties

3. Two-component addition-curing system, low viscosity

4. Non-corrosive, deep curing capability, low linear shrinkage

2. Product Applications

1. High voltage resistor encapsulation, relays

2. Industrial controls, transformers, amplifiers

3. Power modules, connectors, sensors

4. Thermal insulation potting for electronic components

3. Product Specifications

4. Product Usage Method

First, accurately weigh the A and B components according to the ratio, then mix them evenly until the color is uniform. Under vacuum conditions (≥700mmHg), perform vacuum degassing for about 10 minutes. After degassing, proceed with potting or casting. Allow the mixture to stay at room temperature for at least 12 hours to cure into a rubbery elastomer.

5. Precautions

1. During vacuum degassing, the volume of the adhesive may expand significantly, so use an appropriate container to prevent overflow.

2. Curing at elevated temperatures can speed up the process but may also increase the linear shrinkage rate (Higher curing temperature, bigger linear shrinkage). For precision products, it is recommended to cure at room temperature or avoid high-temperature curing. If rapid curing at high temperature is required, the problem of linear shrinkage should be considered.

3. The working life of the silicone rubber is temperature-dependent: higher temperatures reduce working time, and vice versa.

4. Complete the operation within the specified pot life.

5. Before vulcanization, avoid contact with organic compounds that could affect curing, such as unsaturated hydrocarbon plasticizers, residues of flux, and substances containing amines, phosphorus, sulfur, sulfone, arsenic, organic tin, etc.

6. Conduct compatibility tests between the silicone rubber and the substrate before use.

7. This product has not been tested or stated to be suitable for medical or medicinal use.

8. The data provided is for reference only.

6. Cleaning

Uncured silicone rubber can be cleaned with hydrocarbons such as toluene or 120# gasoline. Polar solvents such as ketones and alcohols are not suitable.

7. Product Packaging

This product is available in two standard packaging options: 20KG and 200KG plastic or metal drums.

8. Product Storage and Transportation

Liquid silicone rubber is classified as non-hazardous and can be transported accordingly. Store sealed in a dry, cool place with temperatures below 30℃, with a shelf life of 6 months.

9. Safety Instructions

The main components of liquid silicone rubber are considered essentially harmless after years of application. Use general industrial safety and health regulations. This document does not include the required product safety information, read the product manual before use, and contact us for the relevant safety data sheet if needed.

10. User Attention

The information in this manual is accurate to the best of our knowledge. Our company guarantees the product's compliance with sales specifications upon shipment. However, as the conditions and methods of using our products are beyond our control, this document should not substitute to replace the user testing. Users must test first to ensure the product and process are suitable for their intended use.